Rockwell Automation 1757-SWKIT3200 ProcessLogix R320.0 Installation and Upgrade Guide - Manual (Page 206)

Publication 1757-IN032B-EN-P - April 2001
5-20 Supplementary Procedures
Installing and Running
VirusScan with
ProcessLogix
About VirusScan
Problems with starting up and synchronizing Servers and crashing of the
VirusScan program can result from running the VirusScan concurrently
with the ProcessLogix software unless the VirusScan is specifically
installed and run as described in this section.
The problems noted above have occurred with version 4.0.2 of Network
Associates (formerly known as McAfee) VirusScan NT, when running
automatically upon startup or during file access.
If the Network Associates VirusScan NT program is already installed on
your ProcessLogix Server, go to the next section to remove it. Otherwise,
go to the section entitled Installing VirusScan NT and configuring
directories for scan exclusion.
Removing Existing VirusScan NT Program
If Network Associates VirusScan NT program is currently installed on
the ProcessLogix Server, use the following procedure to remove it from
the PC.
1. Click Start
⇒
Programs
⇒
Network Associates VirusScan
NT
⇒
Uninstall VirusScan NT.
2. Click Yes to confirm the action and follow the on-screen
instructions on the Uninstall Wizard to remove the VirusScan NT
program.
3. When the uninstall is completed, restart the PC.
IMPORTANT
If you need to run the Network Associates VirusScan
NT application on a ProcessLogix Server, you must
install and run the application as described in this
section.