Rockwell Automation 1757-SWKIT3200 ProcessLogix R320.0 Installation and Upgrade Guide - Manual (Page 194)

Publication 1757-IN032B-EN-P - April 2001
5-8 Supplementary Procedures
8. Key in this path location in the Open entry field, or use Browse to
navigate to the setup.exe file in the Migrate folder.
>C:\Honeywell\TPS50\System\ER\Migrate\SETUP.EXE<
9. Click OK to begin ERDB migration.
After ERDB has been migrated, you will be notified of any fatal errors
that occurred during the import migration. You will have the option to
reattempt the import of those ERDB components or to continue with the
migration process without those components. Refer to Recovering from
Failure of an Automatic ER Database Migration on page 5-8.
The list of failed components shown in this dialog box is saved in the
Import Error Log text file located in the C:\ErrorHandling directory. If
you continue to have problems, call Rockwell Automation Technical
Support. Refer to Rockwell Automation Technical Support in the
Preface.
Recovering from Failure of
an Automatic ER Database
Migration
1. In the directory path: C:\Honeywell\TPS50\System\ER,
rename the existing database file:
erdb_a.mdb
to
erdb_a_old.mdb.
ATTENTION
!
If the ER database migration fails importing and
creating the ERDB, the import process must be
performed manually.
Before executing the procedure below to manually
import the database, verify that the conditions that
caused the import to fail have been corrected.
ATTENTION
!
Before installing or uninstalling any software
component, you MUST exit all ProcessLogix
applications and stop all ProcessLogix services.
Refer to Stopping ProcessLogix Applications and
Services on page 1-8.