Rockwell Automation 1757-SWKIT3200 ProcessLogix R320.0 Installation and Upgrade Guide - Manual (Page 133)

Publication 1757-IN032B-EN-P - April 2001
Full PC Software Installation Procedures 3-5
For example, use the name PLX1C for the first ProcessLogix
Client in a redundant Server system.
7. Record the computer name for future reference and click Next.
8. On the Administrator page, key in the password for the
Administrator account twice. The default password for
ProcessLogix systems is “password”.
9. Record the password for future reference and click Next.
10. Click No, do not create an Emergency Repair Disk and click Next.
The Emergency Repair Disk will be created in a later procedure.
11. Click Next to install the default Windows NT components.
Installing TCP/IP Networking Software
Transmission Control Protocol/Internet Protocol (TCP/IP) is a
networking protocol that provides communication across interconnected
networks made up of ProcessLogix Servers and ProcessLogix Clients.
You must install TCP/IP networking software even if your PC does not
include a network card. You cannot run ProcessLogix software without
TCP/IP networking software.
Use the following procedure to install TCP/IP as part of the Windows
NT installation. This procedure assumes that you know the following
information relevant to your communication network.
•
The network name of your PC(s). If you are installing redundant
Servers, the base name for both PCs is always the same and the
name is appended with an A for the Primary Server and a B for the
Secondary Server. For example, the Primary Server name is PLX1A
and the Secondary Server name is PLX1B.
•
The IP address of your PC.
•
The subnet mask for your network.
•
The default gateway, if appropriate.
•
Whether or not you are going to enable Windows Internet Name
Service (WINS) and Domain Name Service (DNS) lookups.
1. Select Wired to the network, when prompted, even if you do not
have a network card.