NewTek TriCaster 8000 User Manual

Page 418

Advertising
background image

Page | 402

For this reason, if you should happen to push the IN button before enabling
recording, it is enabled automatically (illuminating the interface Record button just
as if you had pressed it on the screen).

With Record active, an In Point is set for the current clip that will eventually be
stored (when you press OUT) in the currently delegated DDR (see Section 22.6.3).

Hint: Actually, the IN

button can also be thought of as a ‘reset In Point’ function.

Pressing it updates the In Point, discarding any incomplete clip (i.e., one for which an Out
Point had not been set. The partially recorded data up to that time is simply dropped
(and is not added to the DDR playlist).

ALT

+

IN

A different operation results when you hold down ALT (see Section
22.6.7) at the same time as you push IN. This operation updates the
In Point of the active clip in the currently delegated DDR to the frame
currently displayed.

TW-42

N

OTES

This feature is supported on TW-42 as well.

Hint: This represents a non-destructive edit of the playlist clip, equivalent to dragging the
trim handle at the left-hand end of the DDR scrub bar.

(M

ARK

)

OUT

Pushing the OUT button likewise performs a short series of several actions:

An Out point is assigned to the primary clip

If the Add to switch is enabled in the Record Configuration panel, the clips is
added to any targets configured in the associated destination menu (new
clips are added to the end of the playlist)

Note: This is a non-destructive operation. Rather than actually chopping the file,
recording continues without interruption, and an instance of the file is added to target
playlists.

FIGURE 367

Advertising
This manual is related to the following products: