Yaskawa CIMR-LU Drives - Manual (Page 120)

4 Start-Up Programming & Operation
120 YASKAWA ELECTRIC TOEP C710616 38F YASKAWA AC Drive L1000A Quick Start Guide
Connecting the Drive and Battery
Use the 1.1 m cable packaged with the drive to connect the battery. Remove the connector covering port CN19 before
connecting the cable to CN19.
Information on battery power ratings can be found in Table 33 .
Note: The connector port location and angle vary by drive model.
DANGER! Switch off the power supply before wiring and connecting the battery cable. Failure to comply will lead to death or serious
injury from electric shock.
Battery Connections for CIMR-LU2A0008 to 2A0075, CIMR-LU4A0005 to 4A0039, and CIMR-LU5A0003 to 5A0027
1. Insert the tip of a screwdriver into the opening on the edge of the CN19 connector cover. Slide the cover off the
drive as indicated in
Figure 61 .
NOTICE: A straight-edge screwdriver should be inserted into the opening provided on the connector cover at the proper angle.
Attempting to insert the screwdriver blade at a different angle could damage the drive.
Figure 54
Figure 61 Removing the Connector Cover
2. Connect the cable provided to the CN19 port.
NOTICE: Be sure that the connector fastens at the correct angle to the drive port. The incorrect angle could damage the battery, cable,
or connector.
Figure 55
Figure 62 Connecting the Cable
Press inwards on the tab and
slide the connector cover in the
direction indicated by the arrow.
Press in on the connector
clip to plug in the cable.
Port CN19
TOEP_C710616_38F_5_0.book 120 ページ ２０１３年１２月４日 水曜日 午前９時５６分