Yaskawa CIMR-LU Drives - Manual (Page 57)

4 Start-Up Programming & Operation
YASKAWA ELECTRIC TOEP C710616 38F YASKAWA AC Drive L1000A Quick Start Guide 57
S
tart-U
p
Prog
rammin
g
&
Op
er
at
io
n
4
■ LCD Display
Figure 33
Figure 33 LCD Display
Table 21 Display and Contents
12 ALM LED Light Refer to ALARM (ALM) LED Displays on page 59 .
<1> The STOP key has highest priority. Pressing the STOP key will always cause the drive to stop the motor, even if an Up/Down command is
active at any external Up/Down command source. To disable the STOP key priority, set parameter o2-02 to 0.
<2> The LO/RE key can only switch between LOCAL and REMOTE when the drive is stopped. By default settings the LO/RE key function is
disabled. To allow using the LO/RE key for switching between LOCAL and REMOTE, set parameter o2-01 to 1.
No. Name Display Content
1 Operation Mode Menus
MODE Displayed when in Mode Selection.
MONITR Displayed when in Monitor Mode.
VERIFY Indicates the Verify Menu.
PRMSET Displayed when in Parameter Setting Mode.
A.TUNE Displayed during Auto-Tuning.
SETUP Displayed when in Setup Mode.
2 Mode Display Area
DRV Displayed when in Drive Mode.
PRG Displayed when in Programming Mode.
3 Ready Rdy Indicates the drive is ready to run.
4 Data Display – Displays specific data and operation data.
5
Speed Reference Source
Assignment
<1>
OPR Displayed when the speed reference source is assigned to the LCD Operator.
COM
Displayed when the speed reference source is assigned to MEMOBUS/Modbus
Communication.
OP Displayed when the speed reference is assigned to an option card.
6
LO/RE
Display
<2>
RSEQ Displayed when the Up/Down command is supplied from a remote source.
LSEQ Displayed when the Up/Down command is supplied from the operator keypad.
RREF Displayed when the speed reference is supplied from a remote source.
LREF Displayed when the speed reference is supplied from the operator keypad.
7
Function Key 1
(F1)
HELP Pressing displays the Help menu.
← Pressing scrolls the cursor to the left.
HOME Pressing returns to the top menu (Speed Reference).
ESC Pressing returns to the previous display.
8 FWD/REV
FWD During Up command
REV During Down command
No. Display Name Function
- MODE -
U1-01= 0.00%
U1-02= 0.00%
U1-03= 0.00A
DRV
Speed Ref (OPR)
Rdy
RSEQ
LREF
FWD FWD/REV
6
5
4
1 2 3
7 8 9
YEA_common
F1
F1
F1
F1
TOEP_C710616_38F_5_0.book 57 ページ ２０１３年１２月４日 水曜日 午前９時５６分