Switches and jumpers on the terminal board, Yea_c ommon – Yaskawa CIMR-LU Drives User Manual
Page 52
Advertising
3 Electrical Installation
52
YASKAWA ELECTRIC TOEP C710616 38F YASKAWA AC Drive L1000A Quick Start Guide
■
Switches and Jumpers on the Terminal Board
The terminal board is equipped with several switches used to adapt the drive I/Os to the external control signals.
shows the location of these switches. Refer to
Control I/O Configuration on page 53
for setting instructions.
Figure 30
Figure 30 Locations of Jumpers and Switches on the Terminal Board
Off
On
Jumper S3
Terminal H1/H2
Sink/Source Sel.
DIP Switch S2
RS-422/485 Termination
Resistor
YEA_c
ommon
TOEP_C710616_38F_5_0.book 52 ページ 2013年12月4日 水曜日 午前9時56分
Advertising