Yaskawa CIMR-LU Drives - Manual (Page 153)

7 Option Card Installation
YASKAWA ELECTRIC TOEP C710616 38F YASKAWA AC Drive L1000A Quick Start Guide 153
Op
tion
Ca
rd
In
st
al
lat
io
n
7
Wire Gauges and Tightening Torques
Wire gauge and torque specifications are listed in Table 47 . For simpler and more reliable wiring, use crimp ferrules on
the wire ends. Refer to the option manuals for the wire size and torque specifications of other options.
Table 47 Wire Gauges and Tightening Torques
Crimp Terminals
Yaskawa recommends using CRIMPFOX 6 by Phoenix Contact or equivalent crimp terminals with the specifications
listed in
Table 48 for wiring to ensure proper connections.
Note: Properly trim wire ends so loose wire ends do not extend from the crimp terminals.
Table 48 Crimp Terminal Sizes
PG Encoder Cables for PG-B3 Option
Yaskawa recommends using a LMA- B-S185Y (complementary output) for cables running between the PG-B3
Option and the PG as show in Figure 94 .
For instructions on wiring the terminal block, refer to Table 46 .
Figure 86
Figure 94 Wiring PG Encoder Cable
Terminal Signal Screw
Size
Tightening
Torque
N m
(lb.in.)
Bare Cable Crimp Terminals
Wire Type Applicable
Gauges
mm 2
Recomm.
Gauge
mm 2
Applicable
Gauges
mm 2
Recomm.
Gauge
mm 2
A+, A–, B+,
B–, Z+, Z–,
FE, IP, IG
M2
0.22 to 0.25
(1.95 to 2.21)
0.75
(18 AWG)
Stranded wire:
0.25 to 1.0
(24 to 17 AWG)
Solid wire:
0.25 to 1.5
(24 to 16 AWG)
0.5
(20 AWG)
0.25 to 0.5
(24 to 20 AWG)
Shielded
twisted pair,
etc.
AO, IG, BO,
IG, ZO, IG
Shielded
cable, etc.
Wire Gauge
mm 2
Phoenix Contact Model
L
mm (in)
d1
mm (in)
d2
mm (in)
0.25 (24 AWG) AI 0.25 - 6YE 10.5 (13/32) 0.8 (1/32) 2 (5/64)
0.34 (22 AWG) AI 0.34 - 6TQ 10.5 (13/32) 0.8 (1/32) 2 (5/64)
0.5 (20 AWG) AI 0.5 - 6WH 14 (9/16) 1.1 (3/64) 2.5 (3/32)
d1 d2 6 mm
(0.24 in.)
L
A+ A- B+ B- Z+ Z- SD FE IP IG AO IG BO IG ZO IG
Ｌ
A
B
C
D
E
F
G
H
TA1
TB1 TB2
（Pin）
3 4 5 6 E 1 2
PG encoder side B3
TOEP_C710616_38F_5_0.book 153 ページ ２０１３年１２月４日 水曜日 午前９時５６分