Yaskawa CIMR-LU Drives - Manual (Page 30)

3 Electrical Installation
30 YASKAWA ELECTRIC TOEP C710616 38F YASKAWA AC Drive L1000A Quick Start Guide
2. Pull forward on the terminal cover to free it from the drive.
Figure 13
Figure 13 Removing the Terminal Cover
Reattaching the Terminal Cover
Models CIMR-LU2A0008 to 2A0075, 4A0005 to 4A0039, and 5A0003 to 5A0027
Power lines and signal wiring should pass through the opening provided. Refer to Wiring the Main Circuit Terminal on
page 46 and Wiring the Control Circuit Terminal on page 50 for details on wiring.
NOTICE: Equipment Hazard. Separate motor and/or braking circuit wiring (terminals, U/T1, V/T2, W/T3, +3, +2, +1,(-), B1, B2, from all
other wiring. Place motor wiring within its own conduit or cable tray with appropriate divider, and use shielded motor cable where
appropriate. Improper wiring practices could result in malfunction of drive due to electrical interference.
Reattach the terminal cover after completing the wiring to the drive and other devices.
Figure 14
Figure 14 Reattaching the Terminal Cover
Models CIMR- LU2A0085 to 2A0415, 4A0045 to 4A0605, and 5A0003 to 5A0027
After wiring the terminal board and other devices, double-check connections and reattach the terminal cover. Refer to
Wiring the Main Circuit Terminal on page 46 and Wiring the Control Circuit Terminal on page 50 for details on
wiring.
Figure 15
Figure 15 Reattaching the Terminal Cover
YEA_common
Connect ground wiring first,
followed by the main circuit,
and then wire the control circuit.
Power lines and signal wiring
exit through the opening provided.
YEA_common
Connect ground wiring first,
followed by the main circuit,
and then wire the control circuit.
YEA_common
TOEP_C710616_38F_5_0.book 30 ページ ２０１３年１２月４日 水曜日 午前９時５６分