Omron HOME SECURITY SYSTEM - MOTION SENSOR FQM1-MMA21 - Manual (Page 102)

79
Wiring Servo Relay Units Section 3-4
External Dimensions
Wiring Screw-less
Clamp Terminal
Blocks Screw-less clamp terminal blocks use clamps to attach wires, and do not
require screws. In addition to control signal wiring to Servo Drivers, clamp ter-
minal blocks can be used to connect sensors and external devices. A ferrule,
however, must be connected to the sensor or external device cable when con-
necting to clamp terminal blocks.
The following table shows the suitable ferrules.
Wiring Method • Inserting Wires
Insert the ferrule into the terminal hole.
• Removing Wires
Push and hold the release button on top of the terminal hole with a small
flat-blade screwdriver and remove the wire.
The following screwdriver can be used when removing wires.
160
4.5 dia.
100 90
41.7
15.9
30.7
Signal switches
Terminating resistance switch
Phase B switches
Manufacturer Model Applicable wire
Phoenix Contact Inc. AI-0.5-10
0.5 mm
2
(20AWG)
AI-0.75-10
0.75 mm
2
(18AWG)
AI-1.5-10
1.25 mm
2
(16AWG)
Nihon Weidmuller Co. Ltd. H 0.5/16 D
0.5 mm
2
(20AWG)
H 0.75/16 D
0.75 mm
2
(18AWG)
H 1.5/16 D
1.25 mm
2
(16AWG)
0 8
0 7
0 6
0 5
0 4
0 3
0 2
+ V
+ V
+ V
+ V
+ V
+ V
+ V NC
4
3
2
1
Small minus screwdriver
Release button