Omron HOME SECURITY SYSTEM - MOTION SENSOR FQM1-MMA21 - Manual (Page 32)

9
Expanded System Configuration Section 1-5
1-5 Expanded System Configuration
1-5-1 Serial Communications
The FQM1 system can be expanded using the two serial ports built into the
Coordinator Module: Peripheral port and RS-232C port.
System Configuration
1-5-2 Systems
The serial communications port mode (protocol) can be switched in the Coor-
dinator Module’s System Setup. Depending on the protocol selected, the fol-
lowing systems can be configured.
Protocols The following protocols support serial communications.
CX-Programmer Host computer
Host Link
Automatic detection of
communications parameters Peripheral
port
RS-232C port
Coordinator Module
Protocol Main connection Use Applicable commands and
communications
instructions
Host Link (SYS-
MAC WAY) Personal computer
OMRON Programmable Termi-
nals (PTs)
Communications between the
host computer and the Module Host Link commands/ FINS
commands
No-protocol (cus-
tom) communica-
tions General-purpose external devices
Servo Drivers
Host controllers
No-protocol communications with
general-purpose devices, host
controllers, and Servo Drivers TXD(236) instruction and
RXD(235) instruction
NT Links (1: N) OMRON Programmable Termi-
nals (PTs) High-speed communications with
Programmable Terminals via
direct access None
Peripheral Bus
(Toolbus) CX-Programmer Communications between the
CX-Programmer running on a
computer and the FQM1 None
Serial PLC Link
Slave OMRON PLC Communications between
OMRON PLC and the FQM1 None
Serial Gateway OMRON Programmable Termi-
nals (PTs)
Servo Drivers
Communications between a PT
and W-series or SMARTSTEP
Servo Drivers via the FQM1 FINS commands