Omron HOME SECURITY SYSTEM - MOTION SENSOR FQM1-MMA21 - Manual (Page 337)

314
System Setup, Auxiliary Area Allocations, and Built-in I/O Allocations Appendix C
Host Link Unit Number
Peripheral Port Settings for NT Link
Serial Communications Mode
Baud Rate
Maximum Unit Number for NT Link (NT Link Max.)
Peripheral Port Settings for Peripheral Bus (ToolBus)
Standard/Customer Setting
Serial Communications Mode
Address Settings Function Related flags and
words
When setting is
read
Word Bits
+147 00 to 07 00 to 1F hex: Unit number 0
to 31
Default: 00 hex
This setting determines the Coordinator
Module's unit number when it is con-
nected in a 1-to-N (N=2 to 32) Host
Link. A412.15 (Peripheral
Port Settings Changing
Flag) At next cycle (Also
can be changed
with STUP (237).)
Address Settings Function Related flags and
words
When setting is
read
Word Bits
+144 08 to 11 02 hex: NT Link
Default: 0 hex
This setting determines whether the
peripheral port will operate in NT Link
mode or another serial communications
mode. Set 02 for NT Link Mode.
Note Communications will not be pos-
sible with PTs set for 1:1 NT Links. A412.15 (Peripheral
Port Settings Changing
Flag) At next cycle (Also
can be changed
with STUP (237).)
Address Settings Function Related flags and
words
When setting is
read
Word Bits
+145 00 to 07 08 hex: Standard NT Link
Default: 00 hex
Only the standard setting of 38,400 can
be used for the NT Link Serial Commu-
nications Mode. A412.15 (Peripheral
Port Settings Changing
Flag) At next cycle (Also
can be changed
with STUP (237).)
Address Settings Function Related flags and
words
When setting is
read
Word Bits
+150 00 to 03 0 to 7 hex
Default: 0 hex
This setting determines the highest unit
number of PT that can be connected to
the FQM1. A412.15 (Peripheral
Port Settings Changing
Flag) At next cycle (Also
can be changed
with STUP (237).)
Address Settings Function Related flags and
words
When setting is
read
Word Bits
+144 15 0: Standard
1: Custom
Default: 0 The standard setting is for 9,600 baud. A412.15 (Peripheral
Port Settings Changing
Flag)
At next cycle (Also
can be changed
with STUP (237).)
Address Settings Function Related flags and
words
When setting is
read
Word Bits
+144 08 to 11 04 hex: Peripheral bus
Default: 0 hex
This setting determines whether the
peripheral port will operate in Periph-
eral Bus Mode or another serial com-
munications mode. Set 04 for
Peripheral Bus Mode.
Peripheral Bus Mode is used to com-
municate with the CX-Programmer. A412.15 (Peripheral
Port Settings Changing
Flag) At next cycle (Also
can be changed
with STUP (237).)