Omron HOME SECURITY SYSTEM - MOTION SENSOR FQM1-MMA21 - Manual (Page 395)

372
Auxiliary Area Allocations Appendix D
Serial Communications Instructions
Note When a double-length operand is used, add 1 to the value shown in the length column in the above
table.
Debugging Instructions
Note When a double-length operand is used, add 1 to the value shown in the length column in the above
table.
Failure Diagnosis Instructions
Note When a double-length operand is used, add 1 to the value shown in the length column in the above
table.
Other Instructions
Note When a double-length operand is used, add 1 to the value shown in the length column in the above
table.
Block Programming Instructions
Instruction Mnemonic Code Length
(steps)
(See
note.)
ON execution
time ( µs)
Hardware
implementation
Conditions
TRANSMIT TXD 236 4 24.1 --- Sending 1 byte
342.6 --- Sending 256 bytes
RECEIVE RXD 235 4 36.2 --- Storing 1 byte
348.9 --- Storing 256 bytes
CHANGE SERIAL
PORT SETUP STUP 237 3 441.1 --- ---
Instruction Mnemonic Code Length
(steps)
(See
note.)
ON execution
time ( µs)
Hardware
implementation
Conditions
TRACE MEMORY
SAMPLING TRSM 045 1 34.6 --- Sampling 1 bit and 0 words
148.3 --- Sampling 31 bits and 6 words
Instruction Mnemonic Code Length
(steps)
(See
note.)
ON execution
time ( µs)
Hardware
implementation
Conditions
FAILURE ALARM FAL 006 3 157.1 --- Recording errors
56.0 --- Deleting errors (in order of priority)
457.0 --- Deleting errors (all errors)
53.6 --- Deleting errors (individually)
SEVERE FAILURE
ALARM FALS 007 3 --- --- ---
Instruction Mnemonic Code Length
(steps)
(See
note.)
ON execution
time ( µs)
Hardware
implementation
Conditions
SET CARRY STC 040 1 0.15 Yes ---
CLEAR CARRY CLC 041 1 0.15 Yes ---
Instruction Mnemonic Code Length
(steps)
(See
note.)
ON execution
time ( µs)
Conditions
BLOCK PROGRAM
BEGIN BPRG 096 2 20.3 --- ---
BLOCK PROGRAM
END BEND 801 1 17.2 --- ---