Omron HOME SECURITY SYSTEM - MOTION SENSOR FQM1-MMA21 - Manual (Page 229)

206
Functions for Servo Drivers Compatible with Absolute Encoders Section 7-7
A606
and
A607 00 to 15 High-speed
Counter 2
Counter
operation
• Absolute
linear
(CW
−)
• Absolute
circular
• Absolute
linear
(CW+)
Absolute
No. of
rotations
PV The same as for high-speed counter 1, except
that the high-speed counter frequency mea-
surement cannot be performed. Motion Con-
trol Module
A608 04 High-speed
Counter 1
Status Absolute No. of Rota-
tions Read Error Flag OFF: No error
ON: Error occurred Motion Con-
trol Module
05 Absolute No. of Rota-
tions Read Completed
Flag OFF: Not reading or reading
ON: Reading completed (This is set at the
completion of receiving serial data on No.
of rotations.)
12 Absolute Offset Preset
Error Flag An error occurred when storing the absolute
offset in the System Setup parameter area.
A609 04 High-speed
Counter 2
Status Absolute No. of rota-
tions read error These flags have the same functions as the
ones for High-speed Counter 1 Status, above. Motion Con-
trol Module
05 Absolute No. of rota-
tions read completed
12 Absolute offset preset
error
A610 05 High-speed
Counter 1
Command Absolute offset preset OFF: No preset
OFF to ON: Offset obtained from multi-turn
data from Servo Driver and the
No. of initial incremental pulses
are stored as the absolute offset.
When defining machine origin, dif-
ference between machine and
encoder's origins is preset as the
absolute offset.
Motion Con-
trol Module
06 Absolute PV preset OFF: Absolute PV preset invalid
OFF to ON: At this point, the absolute PV is
stored in high-speed counter PV 1
(A600 and A601).
Note Refer to 7-7-6 Absolute Present Value
for details on the absolute PV.
07 Absolute No. of rota-
tions read OFF: No. of rotations data read from
Servo Driver invalid
ON: At the rising edge of the signal,
SEN is output to Servo Driver, and
multi-turn data is received from
the phase A input.
A611 05 High-speed
Counter 2
Command Absolute Offset Preset These control bits have the same functions as
the ones for High-speed Counter 1 Command,
above. Motion Con-
trol Module
06 Absolute PV Preset
07 Absolute No. of Rota-
tions Read
Word Bits Function Details Controlled
by