Rockwell Automation 1336T FORCE Series B - Manual (Page 196)

Chapter 5
Programming Parameters
5–70
Adapter Identification Number
[Adapter ID] Parameter Number 300
Parameter Type Source
Display Units x
Drive Units None
Factory Default 2
Minimum Value 2
Maximum Value 2
Adapter Software Version
[Adapter Version] Parameter Number 301
Parameter Type Source
Display Units x.xx
Drive Units None
Factory Default x.xx
Minimum Value 0.00
Maximum Value 9.99
This parameter displays the Standard
Adapter ID.
This parameter displays the software
version number.
Adapter Config
[Adapter Config] Parameter Number 302
Parameter Type Source
Display Units
Drive Units
Factory Default
Minimum Value
Maximum Value
(Not Used In Present Release)
Language Select
[Language Select] Parameter Number 304
Parameter Type Sink
Display Units x
Drive Units None
Factory Default 0
Minimum Value 0
Maximum Value 1
This parameter makes the selection
between two languages:
0 – Primary Language
1 – Alternate Language
Parameter Number 310
Parameter Type Source
Display Units +/–x
Drive Units None
Factory Default 0
Minimum Value –32767
Maximum Value +32767
Data In A1
[Data In A1]
Data In A2
[Data In A2]
Data In B1
[Data In B1]
This parameter displays the SCANport to
drive image which is received from some
device on SCANport.
This parameter displays the SCANport to
drive image which is received from some
device on SCANport.
Parameter Number 311
Parameter Type Source
Display Units +/–x
Drive Units None
Factory Default 0
Minimum Value –32767
Maximum Value +32767
Parameter Number 312
Parameter Type Source
Display Units +/–x
Drive Units None
Factory Default 0
Minimum Value –32767
Maximum Value +32767
This parameter displays the SCANport to
drive image which is received from some
device on SCANport.
NOTE: The Parameters shown here in the range from 300 to 500 are Standard Adapter Parameters Only!
Parameter descriptions for PLC Comm Adapter Parameters are covered in the PLC Comm Adapter User Manual.