Rockwell Automation 1336T FORCE Series B - Manual (Page 21)

Chapter
2
2–1
Installation/Wiring
Chapter Objectives Chapter 2 provides the information needed to properly mount and wire the
1336 FORCE Drive. Since most start–up difficulties are the result of
incorrect wiring, every precaution must be taken to assure that the wiring is
completed as instructed. All items must be read and understood before the
actual installation begins.
IMPORTANT: The end user is responsible for completing the
installation, wiring and grounding of the 1336 FORCE drive and for
complying with all National and Local Electrical Codes.
ATTENTION: The following information is merely a guide for
proper installation. The National Electrical Code and any other
governing regional or local code will overrule this information.
The Allen-Bradley Company cannot assume responsibility for
the compliance or the noncompliance to any code, national, local
or otherwise for the proper installation of this drive or associated
equipment. A hazard of personal injury and/or equipment
damage exists if codes are ignored during installation.
!
Mounting When the 1336 FORCE drive is delivered in a NEMA Type 1 enclosure it
must be mounted so that there is sufficient space at the top, sides and front
of the cabinet to allow for heat dissipation as shown in Figure 2.1.
Figure 2.1.
Mounting Requirements
!
Attention: Care must be taken to
prevent debris (metal shavings,
conduit knockouts, etc.) from
falling into the drive while
performing any installation work
on or around the drive. A hazard
of personal injury and/or
equipment damage exists if foreign
material lodges inside the drive.
JOG
ESC SEL
101.6 mm
(4.0 in.)
JOG
ESC SEL
152.4 mm
(6.0 in.)
152.4 mm
(6.0 in.)
152.4 mm
(6.0 in.)
152.4 mm
(6.0 in.)
UP