Rockwell Automation 1336T FORCE Series B - Manual (Page 76)

Chapter 3
Programming Terminals
3–10
AB0282A
or
or
AB0287A
AB0270A
or
or
EEProm Mode
Reset Defaults
Drive –> HIM
The EEProm mode is used to restore all settings
to factory default values or upload/download
parameters between the HIM and drive (Series
B HIM, Only).
To restore factory defaults:
From the Status Display, press Enter (or
any key). “Choose Mode” will be
displayed.
Press the Increment (or Decrement) key
until “EEProm” is displayed. If EEProm
is not in the menu, programming is
password protected. Refer to Password
Mode later in this section.
Press Enter.
Press the Increment (or Decrement) key
until “Reset Defaults” is displayed.
Press Enter to restore all parameters to
their original factory settings.
Press ESC. Display returns to Choose
Mode Screen.
Press the Stop key to reset the fault.
Note: Reset Defaults only modifies
parameters in RAM. To save in EE, do
a “Save” or to recall what is in EE to
RAM do a “Recall”.
Important: If [Input Mode] was previous-
ly set to a value other than “1,” cycle
drive power to reset.
To upload a parameter profile from the drive
to the HIM, you must have a Series B HIM.
From the EEProm menu (see steps A-C
above), press the Increment/Decrement
keys until “Drive –> HIM” is displayed.
Press Enter. A profile name (up to 14
characters) will be displayed on line 2 of
the HIM. This name can be changed or a
new name entered. Use the SEL key to
move the cursor left. The Increment/
Decrement keys will change the charac-
ter.
Stopped
+0.00 Hz
Choose Mode
Display
Choose Mode
EEProm
EEProm
Reset Defaults
Choose Mode
EEPROM
EEProm
Drive –> HIM
Drive –> HIM
1 A