Rockwell Automation 1336T FORCE Series B - Manual (Page 71)

Chapter 3
Programming Terminals
3–5
Display
When selected, the Display mode allows any of the parameters to be
viewed. However, parameter modifications are not allowed.
Program
Program mode provides access to the complete listing of parameters
available for programming.
Process
The Process mode displays two user-selected parameters with text and
scaling programmed by the user.
EEPROM
This mode allows all parameters to be reset to the factory default settings.
In addition, a Series B HIM will allow parameter upload/download
between the HIM and drive. BRAM (Battery Backup RAM) jumper must
be in “Enable” position in order to change parameters.
Search (Series A, version 3.0 or Series B HIM Only)
This mode will search for parameters that are not at their default values.
Control Status (Series A, version 3.0 or Series B HIM Only)
Permits the drive logic mask to be disabled/enabled allowing HIM removal
while drive power is applied. Disabling the logic mask with a Series A HIM
below version 3.0 can be accomplished with [Logic Mask] as explained on
page 3–4. This menu also provides access to a fault queue which will list the
last four faults that have occurred. “Trip” displayed with a fault indicates the
actual fault that tripped the drive. A clear function clears the queue – it will
not clear an active fault.
Link
Link mode provides a method of transferring data from a source parameter
to a linkable sink parameter. When a PLC Comm Adapter Board is used,
up to (50) links are allowed. Links can be programmed only when the
Drive is not running. Links are stored in BRAM and established at power
up, BRAM recall, and/or system reset.
Password
The Password mode protects the drive parameters against programming
changes by unauthorized personnel. When a password has been assigned,
access to the Program/EEProm modes and the Control Logic/Clear Fault
Queue menus can only be gained when the correct password has been
entered. The password can be any five digit number between 00000 and
65535.
Refer to the Password section of the example that follows.