Rockwell Automation 1336T FORCE Series B - Manual (Page 84)

Chapter 3
Programming Terminals
3–18
or
or
Startup Mode
Choose Mode
Startup
Choose Mode
Display
Base Motor HP
30.0 HP
Setup Motor
Nameplate N
An automated Quick Startup sequence is
available on the HIM to lead you through all
data entry, configuration and diagnostic tests
that must be performed when starting up the
1336 FORCE drive.
From the Status Display, press Enter (or
any key). “Choose Mode” will be
shown.
Press the Increment (or Decrement) key
until “Startup” is displayed. Press Enter.
The “Setup Motor Nameplate” display
will appear. If you DO NOT need to
enter motor nameplate data toggle to the
No (N) selection and press Enter.
A display asking you to run the Motor
Connect Diagnostics will appear.
If you have not previously entered the
Motor Nameplate data toggle to the Yes
(Y) selection in the Setup Motor
Nameplate display and press Enter.
The first motor informational screen
will appear. Use the Select key to
access the second line and make any
changes with the Increment and Decre-
ment keys. In subsequent displays you
will be asked to provide the following
motor information:
Base Motor Current
Base Motor Volts
Base Motor Frequency
Motor Poles
Base Motor Speed
Feedback Device Type
NOTE: For more information on the
complete Quick Startup sequence refer
to Chapter 4. All tests and entries are
covered in greater detail in the Startup
chapter.
or
Motor Connect
Diagnostics? Y