Rockwell Automation 1336T FORCE Series B - Manual (Page 74)

Chapter 3
Programming Terminals
3–8
or
Bit ENUMs
Masks
Logic Mask
TB3
X1111111
With drive software versions above 2.00 and
a Series A (software version 3.0) or Series B
HIM, bit ENUMS (16 character text strings)
will be displayed to aid interpretation of bit
parameters.
Select a bit parameter with the Increment
(or Decrement) keys.
Press the SELect key to view the ENUM
of the first bit. Pressing this key again
will move the cursor to the left one bit.
A blinking underline cursor will indicate
that you are in the Display mode or that a
Read Only parameter as been accessed. A
flashing character will indicate that the
value can be changed.
Individual bits of a Read/Write parameter
can be changed in the same manner.
Pressing the SELect key will move the
cursor (flashing character) one bit to the
left. That bit can then be be changed by
pressing the Increment/Decrement keys.
Link The Link Option allows you to view all
current links in the drive and change or
clear these links.
From the Status display, press Enter.
“Choose Mode” will be shown.
Press the Increment or Decrement key to
reach the Link Option.
Press Enter and either the Clear Links or
Set Links option screen will appear.
Toggle between the screens using the Inc
or Dec key.
From the Clear Links screen use the
Enter key to clear all links.
To change links, use the Inc or Dec key
to reach the link you wish to change.
Use the Sel key to access the 2nd line in
the display and then change the link
using the Inc or Dec key.
Choose Mode
Process
Choose Mode
Link
or
Link
Clear All Links
Drive SW Version
< 1 > < – – 0 >
or
or