Hypertherm V9 Series Phoenix Rev.11 - Manual (Page 147)

Phoenix 9.76.0 Installation and Setup Manual 806410 147
6 – Special Setups
Arc Speed Limit: Allows the user to turn off the Speed Limit Check that is performed by SoftMotion for arcs larger than
254 mm (10 inches). This compensates for abrupt motion commands caused by non-tangent line arc
segments and smooths out motion.
Password: Allows the user to enter a new password for Machine Setups. Numbers or letters can be used.
Special Password: Allows the user to enter a new password for Special Setups. Numbers or letters can be used.
Station Configuration Password: Allows the user to enter a new password for Station Configuration setups.
Numbers or letters can be used.
Force Simulation: Disables the motion control card (or MCC) to simulate motion on the screen.
HD3070 Auto Gas: When enabled, this setting allows the CNC to communicate with the auto gas console for the
HD3070 and give access to the auto gas setup screen.
Tangent Angle: Sets the degree of the tangent angle for motion control.
Segments within a part that intersect at angles greater than the selected tangent angle decelerate to zero or
to the minimum corner speed.
Segments within a part that intersect at angles less than or equal to the selected tangent angle, do not
decelerate unless the next segment is a speed-limited arc.
Touchscreen Installed: Enables full keyboard control of the software. Using keyboard control enables a set of key
combinations for accessing the soft keys and other screen controls.
Status/Feature List
The Special Setups screen lets you enable or disable software features in the Status/Feature list. To change the status of
a software feature, double-click or press Space.
Adding Folders: Select whether the CNC operator can add folders from the parts directory on the CNC or the host
computer.
Deleting Folders: Select whether the CNC operator can delete folders from the parts directory on the CNC or the host
computer.
Deleting Files: Select whether the CNC operator can delete folders from the parts directory on the CNC or the host
computer.
Mapping Drives: Select whether the CNC operator can map to external drives from the CNC through the optional
network.
Configuring Watch: Select whether the CNC operator can change the items in the Watch Window.
Add, remove, or change processes: Allows you to restrict the operator’s ability to add, remove, or change a cut chart.
Torch Spacing: When enabled, turns on manual torch spacing in the Manual Options screen. This feature allows the
operator to control torch positioning before running a part program in a multiple-torch system.