System axis screens, Machine setups screen – Hypertherm V9 Series Phoenix Rev.11 User Manual
Page 58
58
Phoenix 9.76.0 Installation and Setup Manual 806410
2 – Machine Setup
System axis screens
Machine Setups screen
Use the Machine Setups screen to define the machine orientation, choose the axes you have on your cutting system, and
enter the number of torch height controls. To open the Machine Setups screen, choose Setups > Password > Machine
Setups.
X Axis Orientation: Specifies the X axis as the Transverse or Rail axis. The default setting is Transverse.
Up Direction: Defines the machine motion when the
↑ arrow key is pressed in manual mode.
Right Direction: Defines the machine motion when the
→ arrow key is pressed in manual mode.
X and Y Motor/Encoder: Select Swapped to swap the X and Y axis encoder signals internally. This feature simplifies
the installation of systems with alternative wiring configurations.
Dual Gantry Installed: Select Yes to enable the Dual Gantry axis for a second side drive. The Dual Gantry axis is always
parallel to the Rail axis.
CBH Installed: Select Yes to enable the contour bevel head axis and allow configuration of that axis.
Tilt Rotator Installed: Tilt Rotator describes an ACXYZ bevel head, which as a rotational axis (C) combined with a tilt
axis (A). Choose this option when your cutting system has this type of bevel head installed.