Phoenix link – Hypertherm V9 Series Phoenix Rev.11 User Manual
Page 245
Phoenix 9.76.0 Installation and Setup Manual 806410
245
Section 13
Phoenix Link
The Phoenix Link communication software is used on the CNC for transmission of part and consumable database files
between the CNC and the host computer. The program uses a 2X compression feature that allows the communication
system to operate at speeds up to 230 K baud.
When the Phoenix Link communication software is operating, the following window displays at the host computer for
configuration. After the software is running, the window can be minimized.
Port: Allows you to select the communication port on the host computer.
Baud: Allows you to select the baud rate for communication on the host computer. The minimum baud rate is 9600 bps;
the maximum baud rate is 115,200 bps.
Folder: Allows you to change the path of the Master folder (in the Parts folder). Subfolders and the part files within this
folder are viewed at the CNC.