Hypertherm V9 Series Phoenix Rev.11 - Manual (Page 94)

94 Phoenix 9.76.0 Installation and Setup Manual 806410
2 – Machine Setup
Fume Extraction Sense: If selected, this input confirms that an external Fume Extraction system on the cutting table is
operational before beginning the cut. An option to override is displayed if the input has not been satisfied at
the time of the cut.
Gas Control Error: Used as part of the HD3070 Automatic Gas Console communications to indicate an error from the
Auto Gas Console.
Gas Control Read Comp.: Used as part of the HD3070 Automatic Gas Console communication to confirm that
communication is complete.
Joystick (Direction): Command manual motion (up, down, left, and right) when using an external joystick.
Limit Switch: Indicates that the machine has traveled to its full positive travel of an axis. If hardware overtravels are
enabled and this input is activated, the CNC stops all motion and generates a fault message. Motion is not
re-enabled until the switch is deactivated. (Type “M” configuration only.)
Marker Select 1 & 2: Select which Marker process logic is used by the CNC. These inputs are generally run by external
switches. (Type “V” CNCs.)
Nozzle Contact Sense: Used during Sensor THC IHS to detect the location of the cut surface. This input is returned to
the CNC through the external voltage divider card.
Pierce Complete: Used for the laser cut process to confirm that the pierce is complete.
Plasma Select 1 & 2: Select which Plasma process logic is used by the CNC. These inputs are generally run by
external switches. (Type “V” CNCs.)
Power Supply OK: Used for the optional Automated Process Controller (APC). It confirms a ready condition from the
plasma power supply before beginning the cut process.
Preheat Sense: Indicates that the preheat input from the torch is active.
Program Inhibit: Forces the CNC to command the motion output to a zero (0) speed. This is generally used as a dwell
to pause motion during a tool change or as a pause from a PLC interface.
Raise /Lower 4070 1 – 2: Used as a manual raise/lower command to the selected HD4070 integrated THC through
the CNC serial power supply communication link. This input is exclusive to the HD4070 multiple power
supply configuration.
Raise/Lower Torch: Operates multiple Sensor THCs when multiple Sensor THCs are commanded by the CNC as
separate axes. The Torch Raise and Torch Lower commands can be issued with soft keys or through these
external inputs to the CNC. (Type “V” CNCs.)
Ready to Fire PS 1 – 4: Ensures that all HD4070 power supplies have completed each individual Initial Height Sense
and are ready for use. The torch ignition is held off by the Hold Ignition Input to the power supply from the
CNC. This input is exclusive to the HD4070 multiple power supply configuration.
Remote Pause: Stops all CNC motion and displays the Pause screen. No motion is allowed until this input is
deactivated.
Remote Start: Begins the selected program cycle as if the Start button on the CNC had been pressed.
Rotate +/-: Used for manual jog commands for the rotate axis.