Lan and hypernet tests, Joystick and speedpot test – Hypertherm V9 Series Phoenix Rev.11 User Manual
Page 197
Phoenix 9.76.0 Installation and Setup Manual 806410
197
8 – Diagnostics
LAN and Hypernet Tests
The LAN and Hypernet tests both use the same tester.
Conduct this test if:
The CNC is not communicating to the ArcGlide or plasma system.
The CNC is not communicating to the local area network.
To test a LAN port:
1. On the Machine Interface screen, choose the LAN or Hypernet port.
2. Follow the instructions on the screen to plug in the tester.
3. On the Machine Interface screen, choose Test. A message informs you if the test is successful.
If either test fails, contact your OEM or system integrator to replace the motherboard.
Joystick and Speedpot Test
To test the joystick and speedpot port:
1. On the Machine Interface screen, choose the joystick/speedpot port.
2. Follow the instructions on the screen to connect the Hypath (purple) tester to the Joystick/Speedpot port, Axis 1 – 2
port and the I/O 1 – 6 port.
WARNING
To prevent motion on the table, disconnect all axis cables from the CNC before
conducting this test.