Adjusting default cut chart settings from the cnc – Hypertherm V9 Series Phoenix Rev.11 User Manual
Page 173
Phoenix 9.76.0 Installation and Setup Manual 806410
173
7 – Plasma Setup
Adjusting default cut chart settings from the CNC
After the MAXPRO200 is connected to the CNC and set up in the Phoenix software, you can control certain parameters
from the MAXPRO200 cut chart, namely the current or the gas pressure, if you need to override the default values.
Choose the Plasma 1 or 2 Cut Chart soft key on the Main screen to open the cut chart.
The cut chart processes you can select in Phoenix have been developed and tested to produce the greatest balance
between cut quality and productivity. If you need to override these default values, you can enter or select the new values
from the MAXPRO200 cut chart screen. Any changes you make to this screen will be applied when you choose OK to
exit the screen.
The gas pressure values in each cut chart for the MAXPRO200 are based on the detected lead length currently in
use. The default gas pressures will vary slightly for each process depending on your system’s lead length.