Retrieving an image file – Hypertherm V9 Series Phoenix Rev.11 User Manual
Page 206
206
Phoenix 9.76.0 Installation and Setup Manual 806410
8 – Diagnostics
Retrieving an Image File
To retrieve an image file:
1. Place the Norton USB memory device into the CNC.
2. Turn the CNC on. Norton Ghost displays:
Starting PC DOS.......
Select 1 to make a New Backup Image or 2 to restore existing [1,2]
3. Press 2 to retrieve the backup image.
You can create up to three custom images. They are created as newest to oldest image. The original ghost image is
the factory default. The next message allows the user to select which version to use when restoring:
1. Newest.gho
2. Older.gho
3. Oldest.gho
4. Original.gho
Select the Number of the Image to restore from the choices above [1,2,3.4 ]
4. Press the number for the image that you want to retrieve.
--------------------Restoring, Please Wait ----------------
Norton Ghost launches and displays messages to indicate the progress of the restore. The following message displays
when the restore is complete:
---------End Restoring, Please Remove Disk and Reboot--------
Remove the USB memory device. Turn the CNC off and then on. Table setups and software updates may need to be
reloaded if the image is not current.