H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 22)

9
Figure 8 Login page of the web interface
NOTE:
•
The PC where you configure the device is not necessarily a web-based network management terminal.
A web-based network management terminal is a PC used to log in to the web interface and is required
to be reachable to the device.
• After logging in to the web interface, you can select Device > Users from the navigation tree, create a
new user, and select Wizard or Network > VLAN interface to configure the IP address of the VLAN
interface acting as the management interface. For more information, see the corresponding
configuration guides of these modules.
• If you click the verification code displayed on the web login page, you can get a new verification code.
• Up to 5 users can concurrently log in to the device through the web interface.
• The procedures for logging in to the access controller engine are the same except that the default IP
address of the access controller engine is 192.168.0.100.
Logging in through the access controller engine
To log in to the switching engine through the access controller engine:
1. Log in to the access controller engine by following Logging in through the browser .
2. Configure the oap management-ip ip-address slot 0 command in system view.
ip-address represents the default IP address of the switching engine.
3. Click Switch Engine.
4. On the page that appears, enter the login settings (see Figure 9 ).