H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 67)

54
Viewing all operation parameters of a port
1. Select Device > Port Management from the navigation tree.
2. Click the Details tab.
3. Click the port whose operation parameters you want to view in the chassis front panel.
The lower part of the page displays all operation parameters of the selected port. Values inside the
square brackets are the actual values of the selected port.
Figure 40 The Details tab
Port management configuration example
Network requirements
As shown in Figure 41 :
• Server A, Server B, and Server C are connected to GigabitEthernet 1/0/1, GigabitEthernet 1/0/2,
and GigabitEthernet 1/0/3 or the switch respectively. The rates of the network adapters of these
servers are all 1000 Mbps.
• The switch connects to the external network through GigabitEthernet 1/0/4 whose rate is 1000
Mbps.
• To avoid congestion at the egress port, GigabitEthernet 1/0/4, configure the auto-negotiation rate
range on GigabitEthernet 1/0/1, GigabitEthernet 1/0/2, and GigabitEthernet 1/0/3 as 100
Mbps.