H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 400)

387
Figure 383 Port setup
3. Configure member ports for the port isolation group as described in Table 109 .
4. Click Apply.
The configuration progress dialog box appears.
5. After the success notification appears, click Close.
Table 109 Configuration items
Item Description
Isolate group ID Select the ID of the port isolation group to be configured
Config type
Specify the role of the port or ports in the isolation group.
• Isolated port: Assign the port or ports to the isolation group as an isolated port
or ports.
• Uplink port: Assign the port to the isolation group as the uplink port.
IMPORTANT:
The device does not support uplink ports.
Select port(s)
Select the port(s) you want to assign to the isolation group.
You can click ports on the chassis front panel for selection; if aggregate interfaces
are configured, they will be listed under the chassis panel for selection.
After selecting Isolated port for Config type, you can select multiple ports to
configure.
IMPORTANT:
You cannot configure an isolated port in a port isolation group as the uplink port of
the current or another port isolation group, but you can configure it as an isolated
port of another port isolation group.