H3C Technologies H3C SecCenter UTM Manager - Manual (Page 15)

7
Integration with iMC
H3C SecCenter can be integrated into H3C Intelligent Management Center (iMC). After being
integrated into iMC, SecCenter becomes a component of iMC and appears as a menu of iMC. You can
access all SecCenter functions from the menu. This means that you can manage all devices in your
network, including security devices, from a single place.
To integrate H3C SecCenter into H3C iMC, use the integration tool called SCMTOOL. You may obtain
the tool from your iMC supplier.
When installing H3C SecCenter on the same host as iMC, note the following:
• By default, iMC uses 8080 and 8443 as the HTTP and HTTPS port numbers and SecCenter uses 80
and 443. If you changed these settings during installation, ensure that there are no port conflicts.
• The iMC Alarm Manager and SecCenter both use port 162 to receive traps. To deploy them on the
same host, disable SecCenter from receiving SNMP traps.
• To access SecCenter integrated in iMC, you must use HTTP. HTTPS is not supported in this case.
Using SCMTOOL to integrate SecCenter into iMC
You can install SCMTOOL on iMC PLAT 3.20-R2606H10. Follow these steps to install SCMTOOL and
use it to integrate SecCenter into iMC:
1. In Intelligent Deployment Monitoring Agent, select the Monitor tab and click the Stop iMC button to
stop all iMC processes.
2. Click the Install button to open the component installation page.