Configuring the seccenter – H3C Technologies H3C SecCenter UTM Manager User Manual
Page 246
238
To connect to the SecCenter, you must enable all SNMP versions, create a read-only community named
public and a read and write community named of private.
Enter the following commands in the CLI.
[U200A] snmp-agent sys-info version all
[U200A] snmp-agent community read public
[U200A] snmp-agent community write private
Configuring the SecCenter
1.
Install the SecCenter
Install the SecCenter software on host 192.168.247.194, and visi
from the host to
log in to the SecCenter management webpage.
The default username and password are admin and admin1 respectively.
2.
Register the license
a.
Select the System Management tab.
b.
From the navigation tree, select License Registration under License Management to enter the
license registration page.
c.
Select the license file and then click Apply to complete registration.
3.
Add the UTM device to the SecCenter
Add the UTM device to the SecCenter system so that the SecCenter system can receive the syslog packets
from the UTM device:
a.
Select the System Management tab.
b.
From the navigation tree, select Device List under Device Management to enter the device
management page.
c.
Click Add to enter the page for adding a device.
d.
Type the IP address of GigabitEthernet 0/1 of UTM as the host IP address. Specify the device
label. If the UTM system time zone is UTC, select Greenwich Mean Time for the time calibration.
Leave the default settings for other parameters and click Add.
Configuring intrusion detection on the UTM and specifying
sending logs to the SecCenter
Enabling logging and specifying sending logs to the SecCenter
The log management feature stores logs generated for actions such as packet filtering in the log buffer,
and can send logs to log hosts as configured.
1.
Configure a log host
a.
Select Log Report > Syslog from the navigation tree.
b.
Set the log buffer size.
c.
Configure the SecCenter host IP address as the log host IP address.
d.
Click Apply.