Nortel Networks Circuit Card - Manual (Page 210)

Page 210 of 906 NT5D11 and NT5D14 Lineside T1 Interface cards
553-3001-211 Standard 3.00 August 2005
Installation
This section describes how to install and test the lineside T1 card.
When installed, the lineside T1 card occupies two card slots. It can be
installed into an NT8D37 IPE module.
When installing the lineside T1 card into NT8D37 IPE module, determine the
vintage level module. If the 25-pair I/O connectors are partially split between
adjacent IPE card slots, the lineside T1 card works only in card slots where
Unit 0 of the motherboard card slot appears on the first pair of the 25-pair I/
O connector.
7 Daisy-chaining to MMI On = Yes
Off = No
8 MMI Master or Slave On = Master
Off = Slave
Table 83
Lineside T1 card – CPE or CSU distance dip switch settings (Switch S2, positions 3 – 5)
Distance
S2 Switch
Position 3 S2 Switch
Position 4 S2 Switch
Position 5
0–133 On Off Off
134–266 Off On On
267–399 Off On Off
400–533 Off Off On
534–655 Off Off Off
Table 82
Lineside T1 card – T1 Switch 2 (S2) dip switch settings (Part 2 of 2)
Dip Switch
Number Characteristic Selection