Nortel Networks Circuit Card - Manual (Page 476)

Page 476 of 906 NT7D16 Data Access card
553-3001-211 Standard 3.00 August 2005
Whenever a Primary command is expected, the user may enter the Parity
command (period). If Auto Parity has already been done, the Invalid
Command menu is presented:
The user's port may be set to idle by entering CTRL Z. Any call in progress
will be dropped, and any Ring Again placed will be released. Once the
Primary Command menu has appeared, the user must enter C to place a call.
The DAC will not accept a number in place of a Primary command.
Primary commands
Once the Primary menu has appeared, only primary commands are accepted.
Call (C)
The Call command must be used to place a call once the Primary menu has
appeared. The DAC will not accept a number only.
Invalid Command/Entry
Re-Enter: <SP>
C<CR>
ENTER NUMBER:<SP>
xxxxxxx<CR>
CALLING xxxxxxx
RINGING
ANSWERED
CALL CONNECTED. SESSION STARTS