Nortel Networks Circuit Card - Manual (Page 478)

Page 478 of 906 NT7D16 Data Access card
553-3001-211 Standard 3.00 August 2005
if the access code is less than the maximum number of digits allowed for the
Speed Call list for the associated data DN (DDN).
Note: If the Speed Call feature key is not defined in the software, you
will be notified by the following: Feature key Speed Call not defined.
Both the Autodial and Speed Call commands can be changed with the Modify
command (M). Additionally, the Speed Call number can be changed in the
service change. When this command is entered, the Modify menu appears.
Any of these choices leads to another series of prompts and responses.
By entering A on the keyboard, you enter the Autodial Modify menu.
Respond to the following prompts to change the Autodial number.
Modify Menu:
A - Auto Number D - DCD Control
L - Long Break M - Manual Answer
Q - Quit Modify Menu R - Remote Loopback
S - Speed Call
CTRL Z (Abort Keyboard Dialing)
Select:<SP>
A <CR>
Current Autodial number: zzzzzzz
Enter Autodial number: <SP>
xxxxxxx <CR>
New Autodial number: xxxxxxx