Software configuration – Nortel Networks Circuit Card User Manual
Page 281
NT5D33 and NT5D34 Lineside E1 Interface cards
Page 281 of 906
Circuit Card
Description and Installation
•
stop bits – one
•
software handshake (XON/XOFF) – off
Software Configuration
Although much of the architecture and many features of the LEI card are
different from the analog line card, the LEI has been designed to emulate an
analog line card to the CS 1000 Release 4.5 software. Because of this, the LEI
software configuration is the same as for two adjacent analog line cards.
All 30 E1 channels carried by the LEI are individually configured using the
analog (500/2500-type) Telephone Administration program LD 10. Use
Table 104 to determine the correct unit number and Software Input/Output:
Administration (553-3001-311) for LD 10 service-change instructions.
LEI circuitry routes 16 units (0 – 15) on the motherboard and 14 (0 – 13) units
on the daughterboard to 30 E1 channels. The motherboard circuit card is
located in the left card slot, and the daughterboard circuit card is located in
right card slot. For example, if installing the LEI into card slots 0 and 1, the
motherboard would reside in card slot 0 and the daughterboard would reside
in card slot 1. In order to configure the terminal equipment through the switch
software, the E1 channel number will need to be cross-referenced to the
corresponding card unit number. This mapping is shown in Table 104.
Table 104
Card unit number to E1 channel mapping (Part 1 of 3)
Item
TN
E1 Channel Number
Motherboard
0
1
Motherboard
1
2
Motherboard
2
3
Motherboard
3
4
Motherboard
4
5
Motherboard
5
6
Motherboard
6
7