Nortel Networks Circuit Card - Manual (Page 303)

NT5D33 and NT5D34 Lineside E1 Interface cards Page 303 of 906
Circuit Card Description and Installation
Figure 53
Display Alarm (D A) screen
The Pause command can be used to display a full screen at a time, by entering
D A P. If there is more than one screen in the log, the MMI scrolls the log
until the screen is full, then stops. When ready to see the next screen, press
any key. The display shows another screen and stops again. This continues
until the entire log has been displayed.
Clear Alarm Log
Clear all entries in the alarm log by typing the Clear Alarm Log (C A L)
command.
Display Status
The Display Status (D S) command displays the current alarm condition of
the E1 link as well as the on-hook or off-hook status of each of the 30 ports
of the LEI. Entering this command causes a screen similar to Figure 54 on
page 304 to appear.
The Pause command can be used to display a full screen at a time, by entering
D S P. If there is more than one screen, the MMI scrolls until the screen is
full, then stops. When ready to see the next screen, press any key. The display
shows one more screen, and stops again. This continues until the entire E1
link has been reported on.
Alarm Log
2/03/99 1:48 Yellow alarm on E1 carrier
2/03/99 2:33 E1 carrier level 1 alarm
2/03/99 3:47 E1 carrier level 2 alarm
2/03/99 4:43 E1 carrier performance within thresholds
2/03/99 15:01 Log Cleared