Nortel Networks Circuit Card - Manual (Page 439)

NT7D16 Data Access card Page 439 of 906
Circuit Card Description and Installation
10 (DCE) OFF
“Host On”
(prompts
off) ON
Forced OFF
Not
Hotline Host similar to
MCDS but does not
require DTR to be
ON Modes 8, 9, 10,
and 11 are for
RS232 Host
connectivity
11 (DCE) OFF
“Host On”
(prompts
off) ON
Forced On
Hotline Continuous Hotline
mode when DTR is
ON (VLL)
12 (DCE) ON
“KBD On”
(prompts
on) OFF
Not
Forced OFF
Not
Hotline Terminal similar to
Asynchronous/
Synchronous
Interface Module
(ASIM) when set to
Not Forced DTR
and Not Hotline
Prompt PBDO =
OFF/ON Modes 12 and 13
are for RS422
Terminal
connectivity
13 (DCE) ON
“KBD On”
(prompts
on) OFF
Not
Forced On
Hotline Terminal similar to
ASIM when set to
Not Forced DTR
and Hotline
Table 157
DAC mode of operation selection (Part 4 of 5)
Service changeable downloadable parameters (LD 11)
Operation
mode
Modem/
Gateway/
Host/KBD
Forced
DTR*
Hotline
Type of device
to be connected
Group selection
DEM PRM DTR HOT
* Not prompted for Type = R422. Defaults for Type = R422: DEM = DCE and DTR = OFF.