Nortel Networks Circuit Card - Manual (Page 519)

NT7D16 Data Access card Page 519 of 906
Circuit Card Description and Installation
HOT (OFF) ON Hotline
If HOT = ON, then AUTB = OFF
AUT (ON) OFF Automatic answer
AUTB (ON) OFF Autobaud
Prompt appears only if HOT - OFF
BAUD 0-(7)-8 Baud rate, where:
0 = 110
1 = 150
2 = 300
3 = 600
4 = 1200
5 = 2400
6 = 4800
7 = 9600
8 = 19200
This prompt appears only if AUTB = OFF.
DCD (ON) OFF DCD settings, where:
ON = dynamic DCD
OFF = forced DCD
This prompt appears only if TYPE = R232.
PRM (ON) OFF Prompt mode, where:
ON = prompt (Terminal) mode
OFF = no prompt (Host) mode
DEM (DCE) DTE Data Equipment mode
This prompt appears only if TYPE = R232.
LD 11 – Configure Data Access card. (Part 2 of 3)
Prompt Response Description