Nortel Networks Circuit Card - Manual (Page 866)

Page 866 of 906 QPC513 Enhanced Serial Data Interface card
553-3001-211 Standard 3.00 August 2005
parameters. These parameters must be set for each ports if both ports are
being used.
LD 17 – Serial port configuration parameters.
Prompt Response Description
REQ: CHG Change configuration.
TYPE: CFN Configuration type.
IOTB YES Change input/output devices.
ADAN NEW TTY x
NEW PRT x
Define a new system terminal (printer) port as device x, where
x = 0 to 15.
CDNO 1-16 Use the ESDI card number to keep track of all ports.
DENS DDEN Double density SDI paddle board.
USER xxx Enter the user of port x. The values that can be entered
depend on the software being used. See the Software Input/
Output: Administration (553-3001-311) for details.
XSM (NO) YES Port is used for the system monitor.