Nortel Networks Circuit Card - Manual (Page 417)

NT6D80 MSDL card Page 417 of 906
Circuit Card Description and Installation
Manually controlled maintenance
Use manual maintenance commands found in the following programs to
enable, disable, reset, get the status of, and perform self-tests on the MSDL
card:
• Input/Output Diagnostic Program LD 37
• Program LD 42
• Link Diagnostic Program LD 48
• PRI D-channel Diagnostic Program LD 96
For a complete discussion of these programs, refer to Software Input/Output:
Administration (553-3001-311).
Note 1: Enter commands after the dot (.) prompt.
Note 2: The “ x ” in the commands below represents the DNUM value of
the card number.
Enabling the MSDL
Enter ENL MSDL x to enable the MSDL manually. If the MSDL base code
has not been previously downloaded or if the card version is different from
the one on the system disk, the software is downloaded and the card is
enabled.
To force software download and enable the card, enter ENL MSDL x FDL .
This command forces the download of the MSDL base code and the
configured peripheral software even if it is already resident on the card. The
card is then enabled.
To enable a disabled MSDL and its ports, enter ENL MSDL x ALL . This
command downloads all peripheral software (if required) and enables any
configured ports on the card. This command can be issued to enable some
manually disabled ports on an already enabled MSDL.