INFICON 3000 Micro GC Gas Analyzer Operating Manual - Manual (Page 72)

4 - 16
PN
07
4-
51
9-
P1
C
3000 Micro GC Operating Manual
4.3.2 IP Address Configuration
The IP address on the computer must be changed in order to communicate with
3000 Micro GC. Set the IP address as follows, assuming the computer is running
Windows XP operation system:
1 Click Start >> Connect To >> Show All Connections.
2 Click Local Area Connection on the Network Connections window.
3 Click the General tab and click Properties.
4 Highlight Internet Protocol (TCP/IP) and click Properties.
NOTE: If 3000 Micro GC will be set up on a LAN, record all of the computer’s
current IP address settings. It is recommended that an IT specialist be
consulted when any IP addresses are configured on a LAN.
5 Click Use the following IP address.
6 For a direct connection via the crossover cable, the IP address must be set to
10.1.1.100. The subnet mask must be set to 255.255.255.0. The Default
gateway and DNS server can remain blank for a direct connection. See
Figure
4-11 .
Figure 4-11 IP address TCP/IP
7 Click OK in the Internet Protocol (TCP/IP) Properties window and
subsequent window to make the entered IP address effective.