Cluster-cli – Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) User Manual
Page 147
Brocade Mobility RFS7000-GR CLI Reference Guide
133
53-1001945-01
Priv Exec Command
4
cluster-cli
Use this command to cluster all the CLI pertaining to the context it appears. This feature is useful to
configure each switch in the cluster by logging in to one participating switch. This eliminates
administrator time and effort, as one switch configuration can represent the entire cluster.
A new context called
is available to support the cluster-cli. Any commands executed
under this context are also executed in each cluster member.
Syntax
cluster-cli enable
Parameters
Example
RFS7000(config)#show redundancy-members
Member ID : 192.168.100.1
Member State : Peer Seen
Member First Seen : Mar 15 16:24:54 2008
Member Last Seen : Mar 15 16:25:00 2008
Number of HB sent : 38044
Number of HB received : 3
Number of Update sent : 0
Number of Update received : 0
Member Standby Mode : Primary
Member AP adoption count : 0
Member Installed License Count: 0
Member Radio portal Count : 0
Member Associated MU Count : 0
Member Rogue AP detected Count: 0
Member Self Healing AP Count : 0
Member Switch Adopt Capacity : 0
Member Running Image Version :
RFS7000(config)#
enable
Enables the cluster context.