Multicast-throttle-watermarks, Multicast-throttle-w atermarks – Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) User Manual
Page 531
![background image](/manuals/361701/531/background.png)
Brocade Mobility RFS7000-GR Controller CLI Reference Guide
517
53-1001945-01
Wireless Configuration Commands
20
multicast-throttle-watermarks
Wireless Configuration Commands
Use this command to configure watermarks for handling bursts of broadcast/multicast frames.
Syntax
multicast-throttle-watermarks (low)<0-100> (high) <0-100>
Parameters
Example
RFS7000(config-wireless)#multicast-throttle-watermarks low 10 high 20
RFS7000(config-wireless)#
low <0-100>
Configures the low water-mark. If the percentage of free packets in the system is
lower than this threshold, the incoming frame will be dropped.
high <0-100>
Configure the high water-mark. If the percentage of free packets in the system is
between the low water-mark and this value, the packet is subjected to a
random-early-drop. If free packets are greater than this value, the packet is
processed.