Dns-server – Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) User Manual
Page 430
416
Brocade Mobility RFS7000-GR CLI Reference Guide
53-1001945-01
DHCP Config Commands
17
dns-server
Use this command to configure the DNS server’s IP address available to the DHCP clients
connected to the pool. Use the
no dns-server
command to remove DNS server list.
Syntax
dns-server <ip address1A.B.C.D> <ip address2A.B.C.D> <ip address3A.B.C.D>
.....<ip address8A.B.C.D>
Parameters
Usage Guidelines
For DHCP client’s, the DNS server’s IP address is used to map the host name to IP address. The
DHCP client uses the DNS servers IP address based on the order (sequence) configured.
Example
RFS7000(config-dhcp)#dns-server 2.2.2.222
RFS7000(config-dhcp)#
dns-server <IP
addressA.B.C.D>
Configures the DNS Server’s IP address.
•
<IP address>
A.B.C.D>
– Server's IP address.