Static-channel-group – Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) User Manual
Page 346
Advertising
332
Brocade Mobility RFS7000-GR Controller CLI Reference Guide
53-1001945-01
Interface Config commands
12
static-channel-group
Use this command to add an interface to a static channel group.
Syntax
static-channel-group <1-4>
Parameters
Usage Guidelines
This command aggregates individual giga port’s into a single aggregate link to provide a larger
bandwidth. The static channel group is used to provide additional bandwidth in multiples of 1Gbps
on the switch. All MAC layer and higher protocols see only the static channel group (aggregate link)
rather than the individual ports that comprise it.
Example
RFS7000(config-if)#static-channel-group 2
RFS7000(config-if)#
<1-4>
Static channel group to associate the link with.
Advertising