Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 567)

Brocade Mobility RFS7000-GR Controller CLI Reference Guide 553
53-1001945-01
Wireless Configuration Commands
20
•
aifsn – (Arbitration Inter Frame Spacing Number) The wait time (in
milliSeconds) between data frames derived using AIFSN and the
slot-time.
•
cw – (Contention Window parameters) MU’s pick a number between 0 and
the minimum contention window to wait before retrying transmissions.
MU’s double their wait time on a collision, until they reach the maximum
contention window.
•
txop-limit – (Transmit-opportunity): An interval when a particular WMM STA
has the right to initiate transmissions on the wireless medium.
•
acm – Admission Control Parameters.
radius
[accounting |
authentication-protocol |
dscp|dynamic-authorization
|
dynamic-vlan-assignment |
mac-auth-format|
mobile-unit | reauth | server] Modify Radius/802.1X related parameters.
•
accounting (mode) [start-interim-stop (interval)<60-3600> | start-stop
|stop-only] – Used to configure RADIUS accounting parameters.
•
mode – Accounting Mode on the WLAN.
•
start-interim-stop – Accounting Start-Interim-Stop.
•
interval<60-3600> – Interval between successive accounting updates.
•
start-stop – Sends Accounting Start-Stop.
•
stop-only – Sends Accounting Stop only.
•
accounting (server) {A.B.C.D|radius-key} – Modify RADIUS/802.1X server
parameters.
•
primary – Primary RADIUS server. The authentication is hardcoded to
1813.
•
secondary – Secondary RADIUS server.The authentication is hardcoded to
1813.
•
<A.B.C.D> – Radius server IP address (using default port :1813).
•
radius-key – Radius server shared secret, upto 127 characters.
•
accounting (timeout) <1-60300> retransmit<1-100> – Configures RADIUS
accounting parameters.
•
timeout <1-60300> – Time in seconds the switch waits for a response
from the RADIUS server before retrying accounting.
•
retransmit <1-100> – Number of retries before the switch gives up
accounting.
•
authentication-protocol (chap|pap) – Authentication protocol to use in the
radius requests.
•
chap – Challenge Handshake Authentication Protocol.
•
pap – Password Authentication Protocol.
•
dscp<0-63> – Specifies a DSCP (Differentiated Services Code Point) v to
provide QoS to RADIUS packets. The DSCP value must be between 0-63.