Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 394)

380 Brocade Mobility RFS7000-GR CLI Reference Guide
53-1001945-01
Standard ACL Config Commands
15
no
Standard ACL Config Commands
Use this command to negate a command or set its defaults.
Syntax
no(deny|mark|permit)
This command negates all the syntax combinations used in deny , mark and permit commands to
configure the Extended ACL.
Parameters
Example
RFS7000(config-std-nacl)#no permit any rule-precedence 10
RFS7000(config-std-nacl)#
RFS7000(config-std-nacl)#no deny any rule-precedence 20
RFS7000(config-std-nacl)#
RFS7000(config-std-nacl)#no mark tos 4 192.168.2.0/24 rule-precedence 30
RFS7000(config-std-nacl)#
deny Specifies packets to reject.
mark Specifies packets to mark.
permit Specifies packets to forward.