Sensor – Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) User Manual
Page 547
Brocade Mobility RFS7000-GR Controller CLI Reference Guide
533
53-1001945-01
Wireless Configuration Commands
20
sensor
Wireless Configuration Commands
Use this command to configure Wireless Intrusion Protection System parameters.
Syntax
sensor (default-config) (wips-server-ip {primary|secondary})
Parameters
Example
FS7000(config-wireless)#sensor default-config wips-server-ip primary 1.0.2.3
RFS7000(config-wireless)#
default-config
The default configuration sent to sensors when they are configured.
wips-server-ip
{primary|secondary}
Specifies IP addresses of the WIPS server.
•
primary <A.B.C.D> – Specifies the primary IP address of the WIPS server.
•
secondary <A.B.C.D> – Specifies the secondary IP address of the WIPS server.
•
A.B.C.D – IP address in A.B.C.D format.