Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 47)

Brocade Mobility RFS7000-GR Controller CLI Reference Guide 33
53-1001945-01
Common commands
2
Parameters(Global Config)
Example
RFS7000#service diag ?
enable Enable in service diagnostics
advanced-vty Enables advanced mode vty interface.
dhcp Enables the DHCP server service.
diag [enable|limit|period] Use this parameter as a diagnostics tool.
•
enable – Enables service diagnostics.
•
limit – Diagnostic limit command.
•
buffer (128|128k|16k|1k|256|2k|32|32k|4k|512|64|64k|8k)
<0-65535> – Buffer usage warning limit.
•
fan <1-3> – Fan speed limit of the fan number.
•
filesys (etc2|flash|var) – File system freespace limit.
•
inodes (etc2|flash|var) – File system inode limit.
•
load (1|15|5) – Aggregate processor load during the previous minutes,
based on the option selected.
•
maxFDs <0-32767> – Maximum number of file descriptors.
•
pkbuffers <0-65535> – Packet buffer head cache.
•
procRAM <0.0-100.0> – RAM % used by a process.
•
ram <0.0-25.0> – Percent free RAM.
•
routecache <0-65535> – IP route cache usage.
•
temperature <1-8> (critical|high|low) – Temperature limit.
•
period <100-30000> – Set diagnostics period. The default period is set as
1000 milliseconds.
password-encryption
(secret)2 LINE Encrypts passwords.
•
secret (2) – Encrypts passwords with secret phrase, using SHA256-AES256
encryption.
•
LINE – Enter a passphrase for encryption.
pm
(sys-restart) Process Monitor.
•
sys-restart – Enables PMLite to reboot the system when a deamon has been
restarted maximum number of times. The default value is to reboot the system.
This enables the process monitor to restart the system when a process fails.
NOTE: Use the
[no] service pm sys-restart
command to disallow a
reboot of the system eve nafter a process has been restarted to its maximum
number of times. This is useful for debugging purpose.
radius (restart) Enables the RADIUS Server.
set (command-history
<10-300>|reboot-history
<10-100>|
upgrade-history <10-100>) Set service parameters.
•
command-history <10-300> – Sets the size of the command history. The
default value is 200.
•
reboot-history <10-100> – Sets the size of the reboot history. The default value
is 50.
•
upgrade-history <10-100> – Sets the size of the upgrade history. The default
value is 50.
show (cli) Displays running system information.
•
cli – Shows the CLI tree of current mode.
terminal-length <0-512> System wide terminal length configuration.
•
<0-512> – Number of lines of VTY (0 means no line control).
watchdog Enable the watchdog.